HYPERION LED pendant light | Black | Dimmable

At the ceiling mount and at the cable holders, each suspension wire is guided through a small locking pin. Press the pin in with one finger while pulling on the suspension wire with your other hand, or feeding the wire back into the housing, to change the hanging height of the lamp. Thanks to this mechanism, you can still adjust the hanging height even after the lamp has already been installed.

Yes! The light can be switched on and off with a conventional wall rocker switch as well as with the supplied remote control. Important: Operation with a wall dimmer switch is not possible. For this, the built-in transformer would have to be replaced with a TRIAC transformer.

Yes! The lamp comes with built-in LEDs and is ready to use right away. You don't need to buy any additional bulbs – you can simply mount the lamp and start using it. The LEDs have a very long lifespan of over 50,000 hours and are covered by our 3-year warranty.

You have a 30-day right of return with us.

Return policy: In the event of a complaint, we will of course cover the return costs for you and refund the full amount.

As we are a young, self-financed company and already bear the shipping costs to you, unfortunately we cannot also cover the costs of a regular return. If you send your lamp back within 30 days, you will receive the refund amount minus the return shipping costs.

For a stress-free return process, you can simply register your return via our returns portal. There you can keep track of the current status of your return at any time.

Our lights are not smart home-compatible as standard. However, you can connect them to a smart home system. To do this, you need to replace the installed transformer with a suitable Smart Home transformer. Make sure that the new transformer meets the technical requirements of the previous transformer. Our lights are controlled via constant current. The Smart Home system must therefore be designed for constant current luminaires. Constant voltage systems are not compatible with our lights. If you want to continue to adjust the color temperature (warm to cool white), the Smart Home transformer must be CCT-capable.

Our lights are not TRIAC dimmable as standard. However, you can make them TRIAC dimmable. To do this, you need to replace the installed transformer with a suitable TRIAC transformer. Make sure that the new transformer meets the technical requirements of the previous transformer. Our lights are controlled via constant current. The TRIAC transformer must therefore be designed for constant current luminaires. Constant voltage systems are not compatible with our luminaires. The transformer must also meet the minimum requirements of the LEDs (wattage and voltage). Please note that you must then decide whether to use only cool white, warm white or neutral white (both LED colors mixed) during installation.

A card with a QR code is included in your delivery. This will take you to the assembly instructions.

Yes, our remote lights have a memory function that can be used to save a setting. To activate it, wait at least 20 seconds between switching off and on using the wall switch. When operated with the remote control, the previous setting is always saved.

The cable used is 3-wire and has a conductor cross-section of 0.3 mm^2. It is cable type F8870/VDE, has a maximum voltage of 300/500 V and is temperature-resistant up to 180 degrees.